none
PCIHCT fail - "Subsystem Vendor ID register of header table is 0h" RRS feed

  • Question

  • Hi,

    I have another issue with PCIHCT. I test our hardware now on Windows 7 x64. The PCIHCT fails in the "Process logged messages"-step. The Logfile contains the error "Subsystem Vendor ID register of header table is 0h". I applied all filters, the test keeps failing. Is the error caused by the hardware or can I change something in the software to get this test pass?

    The hardware is pretty old, we can't change the PCI configuration space. So I need a solution I can do in software, or are there some parameters I can set that the header-table-checking is ignored?

    Thanks for your help,

    Henry

    Wednesday, November 21, 2012 9:59 AM

All replies

  • The manufacturer of the PCI card would need to change the firmware of the PCI chipset to make the register read only.    Contact the PCI card manufacturer for further assistance.   

    This posting is provided AS IS with no warranties, and confers no rights.

    Tuesday, December 4, 2012 7:18 PM
  • The PCI specification for years stated that a value of zero in the SubSystem Vendor ID meant that the PCI device did not support subsystem ID's, but it was a valid value.  To me this sounds like a test that has gone too far.


    Don Burn Windows Filesystem and Driver Consulting Website: http://www.windrvr.com Blog: http://msmvps.com/blogs/WinDrvr

    Tuesday, December 4, 2012 7:34 PM
  • Hi,

    While running this it was asking the parameter value, whats that parameter value??


    Yesubabu Gude

    Monday, May 20, 2013 8:30 AM