none
Setting Z Index on Polylines RRS feed

  • Question

  • I have an issue where Polylines and Polygons are appearing underneath Map Layers (however pushpins are on top). Our issue is caused by having a large number of map layers that exceed z index 10100, therefore Polygons/Polylines appear under these layers. Its been observed that the Polylines and Polygons with a z index lower than 10100 work as required (Polylines and Polygons are above) and those with a z index higher than 10100 do not display as desired (Polylines and Polygons are below map layers).

    Is there anything that can be done to bring Polylines and Polygons above the layers that exceed z index 10100? I've already tried putting them in a Layer with a z index set to say 15000 but it does not seem to be obeyed.

    Thursday, October 3, 2019 2:26 PM

All replies