none
IMGRAMxx parameter RRS feed

  • Question

  • Hi all,

    i'm developing an image for a 512MB board.

    So far, the image is 18MB large but it is growing.

    Do i need to set the IMGRAM64 since now or only when i exceed 32MB of the image size?

    Why i need to declare it?


    SteMMo
    Wednesday, August 3, 2011 7:45 AM

All replies

  • you can set IMGRAM64 now and set AUTOSIZE=ON (http://msdn.microsoft.com/en-us/library/ms924539.aspx) in config.bib

    typically IMGRAM64 condition the MEMORY section in config.bib


    Luca Calligaris lucaDOTcalligarisATeurotechDOTcom www.eurotech.com Check my blog: http://lcalligaris.wordpress.com

    • Proposed as answer by Misbah Khan Wednesday, August 3, 2011 12:04 PM
    Wednesday, August 3, 2011 8:55 AM
  • Check your config.bib file to see if contains the IMGRAM64.

    Typically it is used to specify different RAM sizes in the MEMORY section of config.bib; it is useful in the case where you are building for different configurations that have different RAM sizes.

    In case you are working with with a configuration (board/device) which has a fixed amount of RAM you will probably not see this variable in the config.bib file.

    To use the maximum amount of available RAM, set the size of the RAMIMAGE and RAM sections to account for the entire RAM and set AUTOSIZE=ON.

    • Proposed as answer by Indrajit K Das Wednesday, August 3, 2011 3:08 PM
    • Unproposed as answer by Indrajit K Das Wednesday, August 3, 2011 3:09 PM
    Wednesday, August 3, 2011 10:15 AM