Find if VHD is bootable. RRS feed

  • Question

  • I've been looking through the Msvm_* classes in the Virtualization WMI Classes and I am finding it difficult to find where I would get information about a VHD, specifically if it is bootable.  This small bit of information is need when moving VM with multiple disks between dissimilar hypervisors such as Hyper-V, XenServer, and VMWare.  Since the way the management of storage is different in some cases I need to mark a disk as bootable.

    Any suggestions (note, its not in Msvm_VirtualHardDiskInfo)

    Thank you



    Friday, October 3, 2008 7:58 PM

All replies

  • As this forum has been decommissioned you won't find a lot support here.   You're better off to ask this question over on the technet forums instead.


    As of 8/22/2008 this forum is de-comissioned, and there's pretty much nobody minding this particular MSDN forum..  all the virtualization support is over in the technet forum



    (note the pinned message at the top of the forum that they are de-commissioning these on the 22nd  )


    Further discussion of this issue should be moved to the technet virtulization forum.


    Monday, November 3, 2008 9:42 PM