locked
Blank pages in between report. RRS feed

  • Question

  • Hello All,

    I am getting blank page in between my report.

    Kindly suggest a way to avoid this.

     

    Monday, December 19, 2011 8:50 AM

Answers

  • Hello Nitin,

     

      Can you just remove the page break setting and then run the report  and check whether still you are getting blank pages or not?

     

    HTH,

    Ram


    Ram
    • Proposed as answer by Elvis Long Wednesday, December 21, 2011 8:12 AM
    • Marked as answer by Rinky2312 Wednesday, December 21, 2011 1:40 PM
    Monday, December 19, 2011 1:05 PM

All replies

  • Hi,

    Try to adjust Width and Left / Right margin of report.

    You can change it from Report properties.


    Regards,

    Asim Bagwan

    Kindly mark the replies as Answers if they help!

    Monday, December 19, 2011 8:52 AM
  • Hi,

      Could you specify where the blank spaces are appearing?  is it in the report viewer or is it while exporting to pdf.

    Some of the reasons why you are getting the blank pages

    1) If your report's body size properties does not match with the page size properties then you will get blank pages while exporting the report to pdf. To overcome this make sure the properties of both your body section and the page layout sections are same.

    2) If there are lots of white spaces in your report design layout , you might get the bank pages. Make sure you adjust the layout such that the white spaces are not visible.

    3 ) Incorrect page break settings in groups/tables.

     

    HTH,

    Ram


    Ram
    Monday, December 19, 2011 8:56 AM
  • With reference to the width settings (Point# 1 in Ram's response above), make sure that the following condition is always satisfied:

    Body Width + Left Margin + Right Margin <= Page Width

    Also, one should ensure that the following is also enforced (though this may not cause the blank page issue reported by you):

    Body Height + Top Margin + Bottom Margin <= Page Height

     


    Dattatrey Sindol
    My BlogDatta's Ramblings on Business Intelligence 'N' Life
    The information provided here is "AS IS" with no warranties, and confers no rights.
    Please mark the post as answered if it solves your problem.
    Monday, December 19, 2011 10:17 AM
  • Hello Ramakrishna,

    Kindly refer the following description:

    Body width: 7 in

    Body Height:11.125in

    And

    Page width:8.7 in

    Page Height:11.125in

    Please suggest me. 

         

    Monday, December 19, 2011 11:01 AM
  • Hello Nitin,

      Does your body height requires completely as the page height? If possible decrease the height of the body and then try to run the report. If there is no information in the footer and if there are any blank rows , then you might get the blank pages.

    Also make sure your left and right margins fall withing 8.7in.

    Are you using any page breaks?

     

    HTH,

    Ram


    Ram
    Monday, December 19, 2011 11:18 AM
  • Hello,

    There is one rectangle ,which page breakatStart property set true,but some times it gives blank page some times not.

    Monday, December 19, 2011 12:02 PM
  • Hello Nitin,

     

      Can you just remove the page break setting and then run the report  and check whether still you are getting blank pages or not?

     

    HTH,

    Ram


    Ram
    • Proposed as answer by Elvis Long Wednesday, December 21, 2011 8:12 AM
    • Marked as answer by Rinky2312 Wednesday, December 21, 2011 1:40 PM
    Monday, December 19, 2011 1:05 PM