none
New to RV, how do I get parameters and then set? RRS feed

  • Question

  • Hello

    I'm new to using reportviewer and RS08.  I've got a report loading on a webform just fine.  However, when I change one of the parameters on the tool bar it causes a postback and the report loads all over again due to my code being in the page_load event.  If I put in a If Not Page.IsPostBack the report loads fine the first time but vanishes after the postback.  My thought is that I need to get all the report parameters whenever postback occurs and then send them back to the reportviewer when the page is loaded again?  Is this right?  How do I do this?  Do I need to setup some OnUnload event for the reportviewer?

    I'm not sure how to handle this issue.  Please help.
    Thursday, October 29, 2009 7:24 PM

All replies

  • Certainly this is standard practice for most people using RS08 and reportviewer?  How do I get the changed parameters before postback and then set them after postback?
    Friday, October 30, 2009 7:13 PM