none
related to ports RRS feed

  • Question

  • Hello ,

    sir what is the difference between static one way port and the dynamic response port ?

    thanking you

    sushil sahu


    sushil sahu
    Thursday, September 8, 2011 11:31 AM

Answers

  • In orchestration one easy way to set the protocol and location is as shown below based on protocol alias like ftp:// in this example which adapter to use is detected 

    OrcahestrationSendPortName(Microsoft.XLNAGs.BaseTypes.Address) =  Protocol Alias + Destination
    
    e.g.
    
    OrcahestrationSendPortName(Microsoft.XLNAGs.BaseTypes.Address) =  "ftp://" + FTPServerName + "/" + "<Logic to get FileName>"; 


    Don't forget to mark the post as answer or vote as helpful if it does, Regards -Rohit Sharma (http://rohitbiztalk.blogspot.com)
    • Marked as answer by sushil sahu Thursday, September 8, 2011 12:58 PM
    Thursday, September 8, 2011 12:19 PM
    Moderator

All replies

  • For Static one-way you need to specify the protocol(i.e. adapter) and destination at the time of creation.

    A solicit-response  port is a port that waits for a reply from the destination.

    So Dynamic solicit-response  post is a send port that waits for a reply from destination and can be bound to a protocol and location at runtime based on message context properties(BTS.OutboundTransportType and BTS.OutboundTransportLocation).


    Don't forget to mark the post as answer or vote as helpful if it does, Regards -Rohit Sharma (http://rohitbiztalk.blogspot.com)
    Thursday, September 8, 2011 11:50 AM
    Moderator
  • means in dynamic solicit-response port we have to specify the protocol and destination at run time ?

    i didnt use it yet but i was confused in between these two .

    thanking you

    sushil sahu


    sushil sahu
    Thursday, September 8, 2011 12:03 PM
  • In orchestration one easy way to set the protocol and location is as shown below based on protocol alias like ftp:// in this example which adapter to use is detected 

    OrcahestrationSendPortName(Microsoft.XLNAGs.BaseTypes.Address) =  Protocol Alias + Destination
    
    e.g.
    
    OrcahestrationSendPortName(Microsoft.XLNAGs.BaseTypes.Address) =  "ftp://" + FTPServerName + "/" + "<Logic to get FileName>"; 


    Don't forget to mark the post as answer or vote as helpful if it does, Regards -Rohit Sharma (http://rohitbiztalk.blogspot.com)
    • Marked as answer by sushil sahu Thursday, September 8, 2011 12:58 PM
    Thursday, September 8, 2011 12:19 PM
    Moderator