none
Problem with VMINI and DHCP RRS feed

  • Question

  • I get debug messages whilst the OS is booting but don't get Target Control and Run Programs options.

    I guess its tied up with the following VMINI dialog..

    Output

      22140 PID:400002 TID:2ff0006 VMini:: Detected DHCP [REQUEST]

      22149 PID:400002 TID:2d20002 NetbiosOnIpAdded: pLana ABA593C0 (1) up for AdaptIndex=2, IPv4Addr=6d00a8c0, IPv4BAddr=ff00a8c0

      22162 PID:400002 TID:3c30142   +RDR:NetBIOSNotifyFunc: Lana 1, flags: 0x3

      22162 PID:400002 TID:3c30142   +RDR:NetupIndication, lana 1

      22163 PID:400002 TID:3c30142   +RDR:BindToNet: lananum: 1

      22163 PID:400002 TID:3c30142   +RDR:BindToNetbiosTransport

      22164 PID:400002 TID:3c30142   -RDR:BindToNet successful for lana 1

      22164 PID:400002 TID:3c30142   -RDR:NetBIOSNotifyFunc: Lana 1

      24603 PID:400002 TID:3a60002 DHCPv6:STACK,ENTERED INTO THE FUNCTION, Dhcpv6NSIMediaSenseCallback

      24605 PID:400002 TID:3a60002 DHCPv6:MEDIA CONNECTED

      24609 PID:400002 TID:3a60002 DHCPv6:MEDIA CONNECTED on VMINI1

      24609 PID:400002 TID:3a60002 DHCPv6:writted state:1 into reg with dwError:0,

      25209 PID:400002 TID:3f300ce DHCPv6:SENDING SOLICIT  on VMINI1. ErrorCode is 0

      26178 PID:400002 TID:3f300ce DHCPv6:SENDING SOLICIT  on VMINI1. ErrorCode is 0

      28146 PID:400002 TID:3f300ce DHCPv6:SENDING SOLICIT  on VMINI1. ErrorCode is 0

      32080 PID:400002 TID:3f300ce DHCPv6:SENDING SOLICIT  on VMINI1. ErrorCode is 0

    Target is a TI  AM3352 (ARM)

    OS is bult in Debug mode, Kernel debugging and KITL enabled.

    Any ideas greatly appreciated.

    Thx


    DJaus Snr SW Dev (Embedded Systems and .NET)


    Friday, May 29, 2015 11:07 AM

All replies

  • Hi,

    VMINI is a wrapper for KITL connection only, it doesn't provide the "Target control", but creates ethernet interface over KITL.
    Check if SYSGEN_SHELL component is included to your project.

    Best regards, Igor

    Wednesday, June 3, 2015 6:41 AM