Geocode requests loop suddenly returning 500 error RRS feed

  • Question

  • Hello

    I am batch geocoding some sites in a loop in batches of 20, using WPF and URI. (I found that batches larger than 20 were unreliable.) Suddenly, after 20 or so iterations and so a few hundred correct responses, I get a 500 error on every attempt, whatever data I include.

    X-MS-BM-WS-INFO is 0, so I don't think I'm being rate-limited, but I have no idea where to go from here. If I look at my key usage, it says that it's all non-billable, but I'm not really sure what I'm looking for.

    Can anyone offer any advice?



    Wednesday, June 6, 2018 1:44 PM

All replies

  • OK, I think the "Internal Server Error" may have been exactly that - after a few hours of repeated attempts, it's suddenly working again!

    I do wish that "500" was a bit more specific!


    Wednesday, June 6, 2018 2:34 PM
  • Can you provide time range when you were seeing the issue?  Also if you have header details from your response with the 500 error that would be helpful as well.


    Wednesday, June 6, 2018 5:52 PM