locked
Ethernet problem RRS feed

  • Question

  • Hi,
     
    I am working with WINCE 5.0 on Freescale's imx31 board. I have got problem with ethernet.
     

    With KITL/Ethernet , both debugging and normal TCP/IP works fine
    * Without KITL the Ethernet driver Ping itself fails. i tried with ipconfig on target which returned "No IPv4 adapter found"

    I think ethernet is not configured properly, can any one please help how to resolve this problem.

     

    Regards

    Santhosh

    Monday, June 16, 2008 1:29 PM

Answers

All replies

  • Hi Santhosh,

    For platform question, I suggest you post on following forum , where you will get better reply.

    http://www.microsoft.com/communities/newsgroups/list/en-us/default.aspx?dg=microsoft.public.windowsce.platbuilder

     

    Best regards,

    Guang-Ming Bian - MSFT

     

    Friday, June 20, 2008 5:44 AM
  • Dear Santhosh,

    Have you done the below mention settings?

    A . Open Network and Sharing Center-->Change Adapter Setting-->Local Area Adapter-->Internet Protocol Version4(TCP/IPv4)

    Inside this you have to set static ip(Inside there's two content you have to fill)

    1 . ip address : 192.168.200.2

    2 . subnet mask : 255.255.255.0 

    then press ok.

    B . If A is proper , Have you run Tftp?

    C . If A & B is proper , You have to run Tftp in Administrative mode.

    Please Let me know if u have any queries. 

    Regards

    Bruno.X(Software Engineer - IwaveSyatems)


    • Edited by Bruno_Iwave Monday, August 19, 2013 1:14 PM
    Monday, August 19, 2013 12:29 PM