Where should I have to give the baudrate in serialhcibus driver sample RRS feed

  • Question

  • Hi,

    I'm bringing up the Windows serialhcibus driver sample with my UART device. I have updated .inf with my vendor ID and product ID. After successful installation of the Driver, I am able to see the HCI commands at the driver level from the stack. But it is not writing on to my UART/bluetooth device.

    Could you please help me, What might went wrong in this situation.

    Raj kumar Kamsani

    Tuesday, January 17, 2017 2:52 PM

All replies

  • Did you modify the sample according to your hardware, like mem or IO mapping the registers ?

    baudrate can be set by sending IOCTL request to the driver. For Serial IOCTL reference go through the link below


    Wednesday, January 18, 2017 11:06 AM