Is only allowing the "Pan" tool? RRS feed

  • Question

  • HI,

    I have been using Design for months and have loved it, bit when I opened it up today it automatically selected the "Pan" tool. I have tried to select other things but it keeps just going back to the "Pan" tool. Did I maybe adjust something I should not have. Any ideas are welcome.

    Wednesday, October 21, 2009 1:51 AM

All replies

  • Could be something simple then again maybe not :¦

    One thing I can think of - check the letter 'H' on your keyboard to make sure its not stuck or pressed down
    'H' selects the pan tool in Design 3, I assume its the same selection in previous versions?

    Hope this helps

    • Proposed as answer by LeBear Friday, November 13, 2009 4:43 PM
    Wednesday, October 21, 2009 8:27 AM
  • That was it thanks,
    Wednesday, October 21, 2009 3:50 PM
  • Clever!  I was hit with the same problem and this was it!  I hit the H a few times and all was well.


    Friday, November 13, 2009 4:44 PM