none
Foxpro 2.6 to Visual Foxpro RRS feed

  • General discussion

  • I have Complete program in FOX PRO 2.6 under DOS we wont convert this program to Visual FOXPRO under windows without change in statement of program
    Wednesday, October 10, 2018 7:36 PM

All replies

  • Hi Alaa,

    it's nice of you to tell us your current state of your FP version, but what exactly is your question or problem?!?


    Gruss / Best regards
    -Tom
    Debugging is twice as hard as writing the code in the first place.
    Therefore, if you write the code as cleverly as possible,
    you are, by definition, not smart enough to debug it. 010101100100011001010000011110000101001001101111011000110110101101110011

    Thursday, October 11, 2018 5:30 PM
    Moderator
  • And why do you think that should be possible?

    Depending on your code, you might be able to run your existing application in VFP 9, but it will be incredibly ugly.

    Tamar

    Thursday, October 11, 2018 7:57 PM
    Moderator
  • Hi Alaa

    You can use the same FOXPRO 2.6 program in Visual foxpro. i think it will run without any error But you might get following issues

    - The interface of the application will not look good ( the @Say commands starts from top left hand side of the screens)

    - Some commands may not work.

    its suggested that you should change the code into visual foxpro and use the latest features of it.

    thanks

    Sunday, January 20, 2019 7:32 AM